PTFE lining cellular tower
PTFE lining cellular tower
- Information
The traditional lining reaction tower divides the tower section into a number of tower sections with a length of less than 2 meters, resulting in too many flange joint faces, easy to leak, and the tower body is heavy. In particular, many towers can damage the lining due to accidental underpressure during use. The tower body and the tower cap can be made into an integral structure by using the process, and each section of the tower section can be manufactured according to any length actually needed. At the same time, all the inner packings, such as the filler support, the liquid distributor and the feed pipe, can be matched.
Technical parameters
Polytetrafluoroethylene (PTFE) lining tower section:
Maximum diameter : 6000mm length is not limited (vertical horizontal type is not limited)
Use pressure : -0.09-+1.6Mpa
Operating temperature: -100-+200°C
Lining thickness : 2-6mm
Working principle
Make full use of the superiority of PTFE acid and alkali resistant organic materials, and the superiority of high and low temperature positive and negative pressure.
Factory Show
